Valve For Refrigerator Water Line. Shut off the water supply to the refrigerator. Wipe up any puddles of water that you find on the floor behind the refrigerator.
Remove the screws and remove the valve away from the appliance with care. Reconnect the water line to the water valve at the bottom of the refrigerator. These connectors should be color coded, but if they aren’t, make note of which goes where.
If You Suspect Your Refrigerator Is The Source Of The Problem, We.
Then open up the valve for the fridge connection and do the same thing. Push it in until it bottoms out and then secure it with the locking clip. A strong, steady flow could indicate the water valve has become restricted or clogged.
Check For Leaks At All Connections, Then Push The Refrigerator Into Place, As Needed.
Remove the screws and remove the valve away from the appliance with care. Disconnect the 3 water lines connected to the main valve. These connectors should be color coded, but if they aren’t, make note of which goes where.
Clean Off The Copper Pipe With A Rag So That The Water Line Cap Fits Perfectly.
Turn the water flow of the water valve by shutting the sealed valve throughout the water line connecting to the water valve. There will be a small 1/4 inch copper line attached to the cold. If there is no water coming out, the part is bad and the water filter head will need to be replaced.
Where Is My Refrigerator Water Line Shut Off Valve?
Be aware, you may need to detach the copper tubing or incoming water line from the inlet valve port before you can fully remove the panel. Break the bottom access panel towards the back of the fridge with the use of a screwdriver or even a nut driver. With the refrigerator out of its hole, go ahead and proceed to testing.
Set The Nut To The Side, And Carefully Pull The Freezer Pipe Out Of The Fridge By Hand.
Remove those pins and pull the tubing out from its spot. Push the water line beneath the water valve. These fixes will, of course.